Avaya BCC show Commands for IP Services Uživatelský manuál stáhnout pdf (Strana 22)

BCC show Commands for IP Services

1-8

305755-A Rev 00

show ip rip

The

show ip rip

command displays information about the Routing Information

Protocol (RIP) configuration on IP interfaces.

This command supports the following subcommand options:

show ip rip alerts

The

show ip rip alerts

command displays information about the IP interfaces that

have RIP configured but the state of RIP is down. The output includes the

following information:

Mask The subnet mask associated with the interface’s IP

address.

MAC Address The media access control (MAC) address associated with

this interface.

alerts enabled

auth summary

disabled timers

IP Interface IP interface to which the RIP configuration applies.

Circuit # Number of the IP interface circuit in the router’s active

MIB.

State Operational state of the IP interface: up or down.

RIP Sup/Lis Allow this RIP interface to announce/accept RIP routes.

Def. Rt. Sup/Lis Allow this RIP interface to announce/accept the default

RIP route.

Poison Reverse Method used to readvertise routes out the interface on

which they were learned: poison (poisoned reverse),

actual (actual cost), or split (split horizon).

RIP Mode Type of updates RIP sends: rip1 (Version 1 updates), rip2

(Version 2 updates with no aggregation of subnets), or

aggr (Version 2 updates with subnet aggregation).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 75 76

Žádné komentáře

Avaya BCC show Commands for IP Services Uživatelský manuál Strana 22