Avaya BCM450 Průvodce konfigurací stáhnout pdf (Strana 4)

AT&T IP Flexible Reach

Nortel BCM450 Release 1.0 SIP Configuration Guide

*Nortel, Nortel Networks, Nortel (Logo), the Globemark, CS1000 are trademarks of Nortel Networks.

Issue 0.4 Page 4 of 33

1 Introduction

This document provides a configuration guide to assist Nortel Networks BCM450

administrators in connecting to AT&T IP Flexible Reach via SIP trunks

This document does not describe procedures to configure the BCM450

for advanced functionality. For more information and procedures,

please refer to the Nortel technical documentation found on the Nortel

website.

1.1 Pre-IP PBX Configuration Activity

This guide assumes that the administrator is knowledgeable in IP PBX

programming and operations.

An important tool that the administrators should have at their disposal prior to

testing their IP PBX with AT&T IP Flexible Reach is the Wireshark network

protocol analyzer. This software can be used to run traces on problem calls so

the information can be shared with equipment and network engineers. This free

software can be obtained at

http://www.wireshark.org/.

The customer may also use TCPDUMP which can be found on most UNIX and

Linux systems. The customer should have Wireshark or TCPDUMP loaded on a

server that is connected to a LAN switch or hub that can monitor both the

signaling and media packets on any calls between the customer PBX and the IP

Flexible Reach managed router.

1.2 Customer Questions

Section 4 of this guide provides screen shots and instructions for the

configuration of your IP PBX. Should you have questions regarding these

instructions, please contact Brian Stegemoller at +1 (972) 685-6629; ((972) 745-

5139 after 2/22/2010). When calling this number please have the following

information available:

 Company name

 Company location

 Administrator name and phone number

 IP PBX name and software version

1 2 3 4 5 6 7 8 9 ... 32 33

Žádné komentáře

Avaya BCM450 Průvodce konfigurací Strana 4