Avaya Reference for BCC IP show Commands (308603-14.20 Rev 00) Uživatelský manuál stáhnout pdf (Strana 47)

DVMRP show Commands

308603-14.20 Rev 00

3-5

The output includes the following information:

show dvmrp routes main

The

show dvmrp routes main

command displays the main DVMRP routing

table. You can specify routes that match an IP address or routes with a source

network number that matches a portion of an IP address (for example, 192.34.3.3

or 192.34.0.0/16).

This command allows for the following command filter and arguments:

The output includes the following information:

Source Network IP address of the source of multicast datagrams.

State State of the route, as follows:

• C -- Child

• L -- Leaf

• H -- Holddown

• l -- Loop neighbor

Local IP IP address of the local end of the tunnel.

Remote Tunnel IP address of the remote end of the tunnel.

Dominant Router Dominant router address for a virtual interface.

Sub Router Subordinate router address for a virtual interface.

-slot <slot>

Displays routing information for the specified slot only.

If no slot is specified, the current slot is used.

<ip_address/prefix>

Displays information about the routes for the specified

IP addresses.

Network/Mask IP address and mask of the route.

Next Hop Address If the route is generated from the local interface, the IP

address of the local interface is displayed. Otherwise, the

IP address of the source that sends this route is

displayed.

Slot Slot number on which this route is learned.

Next Hop CCT Number of the next-hop circuit on which this route is

learned.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 77 78

Žádné komentáře

Avaya Reference for BCC IP show Commands (308603-14.20 Rev 00) Uživatelský manuál Strana 47