Avaya Web-Based Management for the Business Policy Switch 2000 Uživatelský manuál stáhnout pdf (Strana 55)

Configuring the switch 55

Using Web-Based Management for the Business Policy Switch 2000

Table 12 describes the items on the IP page.

Table 12 IP page items

Section Item Range Description

Boot Mode

Setting

BootP Request

Mode

BootP When

Needed

Choose this mode to inform the switch to send a BootP request

when the switch IP address stored in nonvolatile memory is the

factory default value. If the stored IP address differs from the

factory default value, the switch uses the stored network

parameters. If the switch cannot find a BootP server, it tries five

more times to find one and then defaults to the factory settings

BootP Always Choose this mode to inform the switch, each time the switch

boots, to ignore any stored network parameters and send a

BootP request. If the BootP request fails, the switch boots with

the factory default IP configuration. This setting disables remote

management if no BootP server is set up for the switch, but it

allows the switch to boot normally.

BootP Disabled Choose this mode to inform the switch, each time the switch

boots, to use the IP configuration parameters stored in

non-volatile memory. If a BootP configuration is in progress

when you issue this command, the BootP configuration stops.

BootP or Last

Address

Choose this mode to inform the switch, at each startup, to obtain

its IP configuration using BootP. If the BootP request fails, the

switch uses the network parameters stored in its non-volatile

memory.

Note: Valid parameters obtained in using BootP always replace

current information stored in the non-volatile memory.

Note: Whenever the switch is broadcasting BootP requests, the BootP process times

out if a reply is not received within (approximately) 7 minutes. When the process times

out, the BootP request mode automatically changes to BootP Disabled mode. To restart

the BootP process, change the BootP request mode to any of the three following

modes: BootP When Needed, BootP Always, or to BootP or Last Address.

IP Setting In-Band Stack

IP Address

XXX.XXX.XXX.XXX Type a new stack IP address in the appropriate format.

In-Band Switch

IP Address

XXX.XXX.XXX.XXX Type a new switch IP address in the appropriate format.

Note: When the IP address is entered in the In-Band IP Address

field, and the In-Band Subnet Mask field value is not present, the

software provides an in-use default value for the In-Band Subnet

Mask field that is based on the class of the IP address entered in

the In-Band IP Address field.

In-Band Subnet

Mast

XXX.XXX.XXX.XXX Type a new subnet mask in the appropriate format.

In-Use The column header for the read-only fields in this screen. The

data displayed in this column represents data that is currently in

use.

Last BootP The column header for the read-only fields in this screen. The

read-only data displayed in this column represents data

obtained from the last BootP reply received.

Gateway

Setting

Default

Gateway

XXX.XXX.XXX.XXX Type an IP address for the default gateway in the appropriate

format.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 219 220

Komentáře k této Příručce

Žádné komentáře

Avaya Web-Based Management for the Business Policy Switch 2000 Uživatelský manuál Strana 55

Komentáře k této Příručce

Související produkty a manuály pro Síťové přepínače Avaya Web-Based Management for the Business Policy Switch 2000