
BayRS, BCC, and Site Manager Software Version 15.0.0.0 Fixed Anomalies
308681-15.0 Rev 00
3
CR 112493-1: BCC
BCC will not allow you to create multiple filters that have the same network/mask
fields but different type fields.
CR 115874-2: DLSw
DLSw may fail to send test polls to the FEP after a line card is replaced by the
Telco.
CR 119140-2: Logical Line Test
Disabling loopback on an MCT1 on an ASN will not cause the interface to come
out of loopback.
CR 119438-1: SNMP
BayRS does not allow you to specify the source IP address in a trap message.
Currently the IP address of the interface that is experiencing the problem is used
as the source address. Enabling the MIB attribute
wfSnmpMgrEntry.wfSnmpMgrCircuitlessTrap causes the router to use the
configured circuitless IP address as the source address.
CR 119877-1: NTP
NTP does not work in broadcast mode. Some symptoms of this are that NTP
drops random updates and that changing modes dynamically either does not work
or causes a bus error on the router.
CR 120372-3: OSPF
When you are adding IP static routes to a host address with a mask of all ones, the
routes are entered in the router’s IP routing table but OSPF never imports them,
preventing any other OSPF router from learning the routes.
CR 121461-1: AHB
When AHB creates the initial configuration file, it misreads the subnet mask.
CR 125149-1: Passport 2430
You cannot set the manager password on the Passport 2430. This fix applies to
Revision 4 of the Passport 2430 CPU board.
Komentáře k této Příručce