Avaya Configuring AppleTalk Services Uživatelský manuál Strana 47

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 128
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 46
AppleTalk Implementation Notes
114048 Rev. A 2-3
Make sure you configure the AppleTalk parameters as follows:
Set the Network Start parameter to the desired value.
Set the Network End parameter to 0, which indicates that the network is
nonextended.
Set the Default Zone parameter for the interface. The network can have only
one zone, the Default Zone.
Set the Network ID and the Node ID for the interface.
Figure
2-1 shows a sample AppleTalk Interface Configuration window for a
nonextended configuration. Note that in the figure, the Network End equals 0.
Figure 2-1. AppleTalk Nonextended Configuration over PPP
Note: If two routers are running Bay Networks Version 7.70 router software or
higher, and you want to configure an interface for AppleTalk over PPP on each
router, both interfaces must be configured the same way for an extended or
nonextended network.
Zobrazit stránku 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 127 128

Komentáře k této Příručce

Žádné komentáře