Avaya Configuring Aura Messaging 6.1 as a Voice Messaging Solution Uživatelský manuál stáhnout pdf (Strana 13)

PM; Reviewed:

SPOC 02/26/2013

Solution & Interoperability Test Lab Application Notes

13 of 47

AAM61SM61BCM60

6. Configure Avaya Business Manager 450 with PRI trunk to

PSTN

6.1. Administer Resources

This section describes how to configure a PRI Trunk on BCM to PSTN.

6.1.1. Administer Application Resource for PRI Trunks

These Application Notes assume that the basic configuration has already been administered.

This section describes steps for configuring Application Resource for PRI Trunks on BCM to

work with Service Provider system.

For further information on Avaya Business Communication Manager 450 configuration, please

consult references in Section 12.

Enable the PRI device on Avaya BCM by select Resources



Telephony Resources.

Under Configured Device column, select DTM + PRI and then click Enable button if it is not

already enable as show in figure below.

Configure PRI trunk parameter as highlighted in red box. Others are left as default:

Trunk type: PRI

Protocol: NI-2

NSF extension: None.

B channel selection: Descending Sequential.

Clock source: Internal.

CO fail: TIA-547A.

Interface levels: ISDN.

Framing: ESF.

Line config: B8ZS.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 46 47

Žádné komentáře

Avaya Configuring Aura Messaging 6.1 as a Voice Messaging Solution Uživatelský manuál Strana 13