Avaya Configuring BayStack Remote Access Uživatelský manuál Strana 40

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 168
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 39
Configuring BayStack Remote Access
1-20 117341-A Rev. A
Netboot
Complete the following steps for the Netboot option:
1. Use the Configuration Manager in local mode to create a complete
configuration file for the BayStack router. (See Cha
pter 3 and Configuring
and Managing Routers with Site Manager.)
2. Set up a UNIX workstation on the network to support BootP. (See Chapter 2.)
3. Use Site Manager to enable BootP on each router interface between the
BayStack router and the BootP server. (See Cha
pter 3.)
4. Ensure that there is a network connection from a synchronous, Ethernet, or
token ring (ARN only) interface on the BayStack router to the upstream
router.
5. Install the kernel and application files in the BootP server’s file system, and
make sure that they reside in the same directory. (See Cha
pter 2.)
6. The person at the BayStack router site establishes a Technician Interface
session, or you establish a session using a modem. (See the hardware
installation manual.)
7. The person at the BayStack router console uses the bconfig and ifconfig
commands to configure a synchronous, Ethernet, or token ring (ARN only)
interface. (See Cha
pter 4 and the hardware installation manual.)
8. The person at the BayStack router site boots the router. (See the hardware
installation manual.)
After the BayStack router boots, it obtains at least one startup file from the
BootP server. If the configuration file meets your network requirements, the
BayStack router starts bridging and routing traffic.
9. Use the Site Manager Statistics Manager and Events Manager tools to verify
that the BayStack router is routing traffic as specified in the configuration file.
(See Configuring and Managing Routers with Site Manager.)
Note: If the BayStack router will connect to the upstream router over a Frame
Relay circuit, ensure that the upstream router is running BayRS Version 7.71
or later.
Zobrazit stránku 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 167 168

Komentáře k této Příručce

Žádné komentáře