Avaya Bay Command Console Uživatelský manuál stáhnout pdf (Strana 69)

Entering Commands

117383-B Rev. 00

3-11

Specifying Multiple Parameter-Value Pairs

Within a specific context in configuration mode, you can

• Enter an object name and one parameter-value pair per command line.

• Enter an object name and multiple parameter-value pairs (each pair separated

by a space) on the same command line.

Example (BN router; specifying one parameter-value pair per line)

box# ethernet 2/1

ethernet 2/1# bofl-retries 6

ethernet 2/1# bofl-timeout 7

ethernet 2/1# hardware-filter enabled

ethernet 2/1#

Example (BN router; specifying multiple parameter-value pairs per line)

ethernet 2/1# ip address 1.2.3.4 mask 255.255.255.0 redirects off

ip.1.2.3.4/255.255.255.0# ospf area 2.3.4.54 hello-interval 5

ospf/1.2.3.4#

Command Operators

BCC command operators perform a named operation within the current or

specified configuration context. All Bay Networks AN/ANH, ARN, ASN, BN,

and System 5000 routers support the following command operators in BCC

configuration mode with read-write privileges (Table 3-1

Note:

The BCC uses required parameters to make up the unique instance

identifier for a configured object. You cannot change the value of any

parameter that makes up the instance identifier for an object. To change these

parameter values, you must delete the object, and then add it back into the

device configuration with new values.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 119 120

Žádné komentáře

Avaya Bay Command Console Uživatelský manuál Strana 69