Avaya CallPilot Message Networking Uživatelský manuál stáhnout pdf (Strana 35)

Chapter 3 Setting up AMIS 35

CallPilot Message Networking Set Up and Operation Guide

Loopback mailbox numbers

You cannot open the Loopback mailbox or perform any mailbox functions from it.

Sending a test network message

To test network message capability you must send a message from your site to the Loopback

mailbox at a site on the AMIS network. When the Loopback mailbox at the destination site

receives the message, it automatically returns the message to the mailbox used at the originating

site. If you use the System Administrators Mailbox, the test message you record is left as a

message in your System Administrator Mailbox. If you receive the message, it indicates Network

Messaging is operating properly. If you do not receive the message or if a protocol error occurs,

see “Troubleshooting Non-Delivery Notification messages” on page 61.

Use the procedure that corresponds to your mailbox interface. For information on determining

which mailbox interface you use, see the CallPilot Reference Guide.

If the mailbox extension

length is:

The Loopback

mailbox number is:

If the Group List leading digit is 1,

the Loopback mailbox number is:

2 digits

13 23

3 digits 103 203

4 digits 1003 2003

5 digits 10003 20003

6 digits 100003 200003

7 digits 1000003 2000003

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 77 78

Žádné komentáře

Avaya CallPilot Message Networking Uživatelský manuál Strana 35