
Configuring IP Utilities
7-2
304234-A Rev 00
Configuring NTP Using the BCC or Site Manager
Table 7-1 lists the NTP configuration tasks described in this chapter and indicates
whether you can use the BCC or Site Manager to perform each task.
Disabling and Reenabling NTP
By default, NTP is enabled when you start it on the router. You can disable and
reenable NTP at any time.
Using the BCC
To disable NTP services, navigate to the NTP prompt and enter:
disable
For example, the following command line disables NTP on the router:
ntp# disable
ntp#
To reenable NTP services, navigate to the NTP prompt and enter:
enable
Table 7-1. NTP Configuration Tasks
Task BCC Site Manager
Disabling and Reenabling NTP
✓✓
Setting the NTP Operation Mode
✓
Adding Remote Time Servers
✓✓
Setting the Mode for a Remote Time Server
✓✓
Setting Local Host Mode
✓
Specifying the Source IP Address
✓✓
Specifying Peer Preference
✓
Deleting Remote Time Servers from a Router
✓✓
Configuring NTP Access Control
✓
Komentáře k této Příručce