
Configuring Traffic Filters and Protocol Prioritization
6-4
308645-14.00 Rev 00
Creating a Template
To create an inbound traffic filter template:
Site Manager Procedure
You do this System responds
1. Display the Filters window (Figure 6-1)
. See
“Displaying the Inbound Traffic Filters Window.”
2. Click on
Template
. The Filter Template Management window opens
(Figure 6-2)
.
3. Click on
Create
. The Create Template window for the protocol opens
(Figure 6-3).
4. Specify a name for the new template in the Filter
Name field.
Use a descriptive name. For example, the name
Drop_Telnet
suggests the criterion and action to drop
Telnet session requests from remote nodes.
5. Choose Criteria > Add >
criterion
.
See Chapter 3 for information about the criteria for
your protocol. Each filter template can use only one
criterion.
The Add Range window opens.
6. Specify a range for the selected criterion. To
specify a hexadecimal number, use the prefix 0x.
You must specify at least one range. If the range
consists of just one value, specify that value in the
Minimum value field. See Chapter 5 for information
about common traffic filter ranges.
7. Click on
OK
. The Add Range window closes. The criterion and
range appear in the Filter Information field of the
Create Template window.
8. To add more ranges, choose Range > Add. Then,
repeat steps 6 and 7.
You can add up to 100 ranges for each criterion.
9. Choose Action > Add >
action
.
10. Click on
OK
. The Filter Template Management window opens
(Figure 6-2). The template appears in the templates
list.
Komentáře k této Příručce