Avaya Connecting ASN Routers and BNX Platforms to a Network Uživatelský manuál Strana 38

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 106
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 37
Connecting ASN Routers and BNX Platforms to a Network
1-18
If the configuration file meets your network requirements, the router starts
bridging and routing traffic.
You can use the Site Manager Statistics Manager and Events Manager tools to
verify that the router is routing traffic according to the configuration you want.
(See the manual Managing Routers and BNX Platforms.)
Directed Netboot
The Directed Netboot option requires the following steps:
1. You use the Configuration Manager in local mode to create a complete
configuration file for the router. (See Chapter 3 and the manual Configuring
Routers or Configuring Customer Access and Trunks (BNX Software),
depending on the type of installed software.)
2. You set up the network to support TFTP. (See Chapter 2.)
3. The person at the ASN site establishes a Technician Interface session (or you
establish a session via modem). (See the manual Installing and Maintaining
ASN Routers and BNX Platforms.)
4. The person at the ASN console issues
bconfig and ifconfig
commands to
configure a synchronous or Ethernet interface for Directed Netboot. (See
Chapter 4 if you are using a remote Technician Interface session, or the
manual Installing and Maintaining ASN Routers and BNX Platforms if at the
ASN site.)
5. The person at the router site boots the router. (See the manual Installing and
Maintaining ASN Routers and BNX Platforms.)
The router boots from a local software image and downloads the
configuration file from a TFTP server.
The router starts bridging and routing traffic.
You can use the Site Manager Statistics Manager and Events Manager tools to
verify that the router is routing traffic according to the configuration you want.
(See the manual Managing Routers and BNX Platforms.)
Note: To use Directed Netboot, make sure the upstream router is running
Router Software Version 8.10 or later (or BNX Software Version 5.00 or later).
Zobrazit stránku 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 105 106

Komentáře k této Příručce

Žádné komentáře