Avaya Connecting BayStack AN and ANH Platforms to a Network Uživatelský manuál stáhnout pdf (Strana 59)

Setting Up a UNIX Boot Server

3-11

Editing the inetd.conf File

Add the following line to the inetd.conf ﬁle to set up a static route:

route add

<destination> is the IP address of the AN/ANH or its network.

<gateway> is the IP address of the network destination to which packets are to be

addressed.

<hops> is the number of hops to the network destination.

Verifying the Routes

After adding a static route for each path to the booting routers, enter the following

command to display the routing table and verify the route you added:

netstat -r

Loading the Changes into Memory

Once you modify the inetd.conf ﬁle, you must force the operating system to reread

it by rebooting the workstation or by issuing a hang-up signal.

In most cases, reboot the workstation. Issue a hang-up signal if the workstation is

performing a task that you do not want to interrupt.

Rebooting

Reboot your workstation as follows:

1. Log in as root.

2. Execute the following command:

/etc/shutdown now -r

The -r ﬂag reboots the workstation.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 167 168

Žádné komentáře

Avaya Connecting BayStack AN and ANH Platforms to a Network Uživatelský manuál Strana 59