Avaya BCM1000 Instalační manuál stáhnout pdf (Strana 105)

Installation and Maintenance Guide

Chapter 6

Installing the BCM1000e (expansion unit)

This chapter describes how to install the BCM1000e.

The BCM1000e must be installed close enough to the BCM1000 that the 5 m (16 ft.) cable

between the two units can be connected to the BCM1000 without stress on the cable. The

BCM1000e has the same environmental and electrical requirements as the BCM1000. For more

information about these requirements, refer to “Preparation checklist” on page 69.

Installing the BCM1000e into a rack

The BCM1000e fits into a standard 19-inch equipment rack. You must install the unit in the same

rack as the BCM1000.

Attaching the mounting brackets

You must install two rack brackets on the BCM1000e to allow you to install the unit into the

equipment rack. These brackets are supplied with the unit.

1 Place the BCM1000e on a table.

2 Align the screw holes between the unit and the right rack mounting bracket. Refer to Figure

32.

Figure 32 Attach the rack mounting bracket to the BCM1000e

Caution: When installing the BCM1000e in a rack, do not stack units directly on top of

one another. Fasten each unit to the rack with the separate mounting brackets.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 310 311

Žádné komentáře

Avaya BCM1000 Instalační manuál Strana 105