Avaya BayRS and BCC Software Version 15.3.0.8 Fixed Anomalies Uživatelský manuál stáhnout pdf (Strana 2)

Q00490837-02: RIP

RIP1 is importing RIP2 multicast updates and installing subnetted

networks in the routing table. A new MIB parameter, wfRipIntfRipCompatible, has been

added to make RIP work in

conformance with RFC 1723. This acts a control switch to determine

whether to accept RIP1 only, RIP2 only or both. It is configurable

on a per interface basis. If enabled, RIP2 packets are broadcast,

RIP1 ignores multicast packets and installs only natural address

and mask in the routing table when it receives a RIP2 packet.

Q00494691-02: PP5430

The PP5430 diagnostic tests intermittently reads the FE-1 SDB ID

as an ISDN and subsequently fails or hangs the router. This is a

software change that compliments the change in the PP5430 V1.16

Diags (available with BayRS 15.4.0.1).

Q00499411: PP2430

On a PP2430 router that is configured for either Dial Backup or Hot

Standby backing up an FT1 link, when the router detects a primary

link failure on the FT1, the ISDN module will stop transmitting.

Q00494678-01: PP5430

A watchdog fault may occur on a PP5430 router when passing small

frame IP traffic.

Q00495479: NAT

The NAT process may fault on boot up due to a timing issue where

it tries to translate before other processes are up.

Q00517502: FT1

Request to allow the ability to turn off FDL (Facilities Data

Link) functionality on the FT-1.

1 2 3 4 5 6 7

Žádné komentáře

Avaya BayRS and BCC Software Version 15.3.0.8 Fixed Anomalies Uživatelský manuál Strana 2