Avaya Bogen Call Stacker Uživatelský manuál

Call StackerInstallation and Use Manual© 1999 Bogen Communications, Inc.All rights reserved. 54-2025-01 9910Model: LULCSTPEC Code: 5325-150COM Code:

2-2InstallationInstallation Steps1.Attach the reversible brackets to the Call Stacker using the 6-32 x 3/8" screws provided, then secure the Cal

Installation 2-32.Set the option switch on the Call Stacker (see Figure 3-1 on page 3-2) for the desired system configuration (refer to Table 2-1).N

2-4InstallationFigure 2-3. Page Output Channel Connection of Call StackerFigure 2-4. Connection to Lucent LUPCM Zone Paging SystemFigure 2-5. C

Installation 2-54. Connect the detachable power supply cord between a 110/120 VAC outlet and the Call Stacker and verify the Power LED illuminates.5.

2-6InstallationThis page intentionally left blank.

Operation 3-1OperationContentsOperation 3-2 Controls and Indicators 3-2 Recording Announcements 3-3 Announcement Playback 3-4Maintenance 3-5 Trou

3-2 OperationOperationControls and IndicatorsFigure 3-1. Rear Panel DetailTable 3-1. Rear Panel DescriptionITEM DESCRIPTIONPower On LED Illuminate

Operation 3-3Recording AnnouncementsVoice Prompts Enabled1.Dial up the input station connected to the Call Stacker. The Call Stacker answers the trun

3-4 OperationVoice Prompts Disabled1.Dial up the input station connected to the Call Stacker and wait for the Call Stacker to answer the trunk and re

Operation 3-5MaintenanceTroubleshootingThere are no serviceable parts in the Call Stacker:If the Call Stacker does not operate during a power failure

© 1999 Bogen Communications, Inc.All Rights Reserved. Printed in U.S.A.NoticeEvery effort was made to ensure that the information in thisguide was com

iiiContents1. Overview 1-1n Introduction 1-2n Before You Start 1-32. Installation 2-1n Installation Steps 2-23. Operation 3-1n Operation 3-

ivThis page intentionally left blank.

Overview 1-1OverviewContentsIntroduction 1-2Before You Start 1-3

1-2 OverviewIntroductionThe Call Stacker is a microprocessor based audio recording and announcement system. The Call Stacker is used in conjunction w

Before You StartBefore installing your system, read and understand the safety instructions onpage ii (inside front cover). Be sure you have all the ne

1-4OverviewTable 1-1. Call Stacker Connectivity Chart.SYSTEM CONNECTIVITYFORWARD DISCONNECTSTATION GROUPINGPARTNER PLUSYes (Release 2 or later)Stand

Installation 2-1InstallationContentsInstallation Steps 2-2