Avaya How to Use the Wall-Mounting Brackets Kit Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro ne Avaya How to Use the Wall-Mounting Brackets Kit. Avaya How to Use the Wall-Mounting Brackets Kit User's Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Part No. 212687-A
February 2002
4401 Great America Parkway
Santa Clara, CA 95054
*212687-A*
How to Use the
Wall-Mounting
Brackets Kit
Zobrazit stránku 0
1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - Brackets Kit

Part No. 212687-AFebruary 20024401 Great America ParkwaySanta Clara, CA 95054*212687-A*How to Use theWall-Mounting Brackets Kit

Strany 2 - Statement of Conditions

10Attaching the module to the wall1 Using the dimensions of the module you intend to mount, drill pilot holes in the wall for the mounting screws.2 In

Strany 3 - Before you begin

113 Set the module in place over the screws. Tighten the screws to secure the module to the wall.4 Attach network cables. Use plastic cable clamps to

Strany 4 - Package contents

12How to get helpIf you purchased a service contract for your Nortel Networks product from a distributor or authorized reseller, contact the technical

Strany 5

2Copyright © 2001 Nortel NetworksAll rights reserved. February 2002.The information in this document is subject to change without notice. The statemen

Strany 6 - Installing a single module

3IntroductionThe optional wall-mounting brackets kit provides you with an alternate method of installing your Nortel Networks* module. Contact your No

Strany 7

4• No excessive dust• Adequate power source within six feet; one 15-Amp circuit required for each power supply• At least 2 inches (5.08 cm) on each si

Strany 8 - Installing two modules

5Installing the module on a wallRequired tools and material:• Phillips screwdriver for attaching brackets to the module• Four screws appropriate to th

Strany 9

6Installing a single module1 Slip a bracket over each side of the module with the bracket tabs against the recessed mounting holes on the bottom of th

Strany 10

72 Fasten the brackets to the module, using two flathead screws in each bracket.To complete the module installation, go to “Attaching the module to th

Strany 11

8Installing two modules1 Set each bracket with the top tabs of the bracket against the recessed mounting holes in the bottom of one module.2 Fasten th

Strany 12 - How to get help

93 Set the second module on its back panel. Slide the first module with attached brackets over the second module.4 Using two flathead screws in each b

Komentáře k této Příručce

Žádné komentáře