Avaya HSSI Net Module in an ASN Platform Uživatelský manuál stáhnout pdf (Strana 18)

Installing the HSSI Net Module in an ASN Platform

1-2

117406-A Rev. A

Removing the ASN Component Tray

You need a Phillips screwdriver to complete this procedure.

To remove the ASN component tray:

Turn off the ASN.

Detach all cables, including the power cable, from the ASN back panel.

Using a Phillips screwdriver, loosen the two captive screws that fasten the

tray to the chassis (Figure 1-1).

Pull out the two captive screws and gently slide the tray out of the

chassis a few inches (F

igure 1-1).

Hold the sides and bottom of the tray to support it as you slide it out;

try to keep the tray level.

Place the tray on a sturdy work surface.

Caution:

Do not touch any ASN components or boards until you have

attached an antistatic wrist strap. See the next section, “Attaching the

Antistatic Wrist Strap.”

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Žádné komentáře

Avaya HSSI Net Module in an ASN Platform Uživatelský manuál Strana 18