Avaya BCM 2.5 IP Telephony Průvodce konfigurací Strana 96
- Strana / 128
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
96 Networking
P0937663 02.0
WAN engineering
Wide Area Network (WAN) links are typically full-duplex links - both talk and listen traffic use
separate channels. For example, a T1 link uses a number of 64 kbit/s (DS0) duplex channels
allowing *64 kbit/s for transmit path and n*64 kbit/s for the receive path.
(WAN links may also be half-duplex.)
Example 1: WAN engineering - voice calls
Consider a site with four IP telephony ports and a full-duplex WAN link using PPP. The preferred
codec is G.729 kbit/s, which uses a voice payload of 20 ms. Silence compression is enabled.
Given the above, what is the peak traffic in kbit/s that IP telephony will put on the WAN?
From Table 12 on page 95, the peak transmission rate for G.729 is 24.8 kbit/s per call or 99.2 kbit/
s in each direction for all 4 calls. In other words, in order to support four G.729 calls, the WAN link
must have at least 99.2 kbit/s of usable bandwidth (in each direction).
From Table 12 on page 95, the average bandwidth for each call is 12.4 kbit/sec per channel or 49.4
kbit/s for all 4 calls for each channel. Low priority data applications can make use of bandwidth
made available by silence suppression.
Additional feature configuration
This section contains additional information on configuring your network to run efficiently.
Setting Non-linear processing
Non-linear processing should normally be enabled.
To set non-linear processing:
1 In Unified Manager, open Services, IP Telephony, and click on H.323 settings. The H.323
parameters appear in the right window.
2 Click the Non-linear processing drop-down menu, and select either Enabled or Disabled.
Determining network loading caused by IP telephony traffic
At this point, the installer or administrator has enough information to load the IP telephony traffic
on the intranet.
Consider the intranet has the topology as shown Figure 47 on page 97, and the installer or
administrator wants to know in advance the amount of traffic on a specific link, R4-R5. Consider
there are four IP telephony ports per site.
- Business Communications 1
- Manager 2.5 1
- IP Telephony Configuration 1
- Trademarks 2
- Contents 3
- Chapter 4 4
- Chapter 5 5
- Appendix A 5
- Before you begin 13
- Symbols used in this guide 14
- Text conventions 14
- Acronyms 15
- UDP User Datagram Protocol 16
- WAN Wide Area Network 16
- Related publications 17
- How to get help 18
- Chapter 1 19
- Introduction 19
- The IP telephony network 20
- Chapter 1 Introduction 21 21
- Figure 1 Network diagram 21
- Telephones 22
- IP Network 22
- Key IP Telephony Concepts 23
- Jitter Buffer 24
- QoS routing 24
- Chapter 1 Introduction 25 25
- 26 Chapter 1 Introduction 26
- Chapter 2 27
- Prerequisites checklist 27
- Network assessment 28
- Resource Assessment 28
- Keycodes 29
- IP Telephones 30
- Chapter 3 31
- Installing IP Telephones 31
- Choosing a codec 33
- Choosing a Jitter Buffer 33
- Before Installing 34
- Manual Cfg DHCP(0 no, 1 yes) 35
- Configuring DHCP 38
- Figure 4 DHCP summary 39
- Figure 5 DHCP range 40
- Figure 6 IP Terminal status 41
- Figure 7 Configuration menu 42
- Figure 9 IP Terminal Status 43
- Download Pending 44
- Deregistering offline DNs 45
- Moving IP telephones 46
- H.323 devices 47
- 4 Click the Save button 49
- VoIP Trunk Configuration 51
- Configuring media parameters 53
- Configuring codecs 54
- Setting Silence Compression 54
- Setting Jitter Buffers 55
- Outgoing call configuration 56
- Figure 21 Trunk/Line data 57
- Figure 22 Line pool 58
- Configuring a remote gateway 59
- Configuring PSTN fallback 60
- Setting up a VoIP schedule 61
- Vo I P 62
- Configuring routes 63
- Figure 28 Route list 64
- Figure 29 Add route dialog 64
- Creating a destination code 65
- Figure 32 Normal schedule 66
- Configuring digits 67
- Activating the VoIP schedule 67
- Turning on QoS monitor 68
- Incoming call configuration 70
- Example configuration 71
- Making calls 74
- Connecting an i200X telephone 75
- Quality of Service Monitor 77
- Port settings 77
- Using firewalls 78
- Using a gatekeeper 80
- Gatekeeper call scenarios 82
- Typical applications 85
- MCDN functionality 86
- Networking 91
- Network Engineering 92
- Networking 93 93
- (64 kb/s) 93
- (5.3 kb/s) 93
- LAN Engineering Examples 95
- WAN engineering 96
- Setting Non-linear processing 96
- Networking 97 97
- Traceroute 97
- Enough link capacity 98
- Not enough link capacity 98
- Implementing the network 99
- Further network analysis 99
- Reduce link delay 100
- Reducing hop count 100
- Adjust the jitter buffer size 101
- Reduce packet errors 101
- Routing issues 102
- Silence compression 103
- Appendix B 103
- 104 Silence compression 104
- P0937663 02.0 104
- Silence compression 105 105
- 106 Silence compression 106
- Silence compression 107 107
- Comfort Noise 108
- Appendix C 109
- Network Performance Utilities 109
- Appendix D 111
- Interoperability 111
- Speech Path Setup Methods 112
- Media Path Redirection 112
- Gatekeeper 113
- Symbol Telephones 114
- Appendix E 115
- Quality of Service 115
- Measuring Intranet QoS 116
- Recording routes 117
- Adjustment for processing 118
- Late packets 118
- Quality of Service 119 119
- Traffic mix 120
- Network Quality of Service 121
- Packet loss 122
- Packet delay 122
- Delay variation (jitter) 123
- 124 Quality of Service 124
- Glossary 125
- 126 Glossary 126
Související produkty a manuály pro Brány / ovladače Avaya BCM 2.5 IP Telephony
Brány / ovladače Avaya IP Telephony Průvodce konfigurací
(146 stránky)
(146 stránky)
Brány / ovladače Avaya Mobile Communication 3100 Planning and Engineering Uživatelský manuál
(54 stránky)
(54 stránky)
Brány / ovladače Avaya 5.0/Business Uživatelský manuál
(156 stránky)
(156 stránky)
Brány / ovladače Avaya BSGX4e Průvodce nastavením
(31 stránky)
(31 stránky)
Brány / ovladače Avaya X.25 Uživatelský manuál
(52 stránky)
(52 stránky)
Brány / ovladače Avaya B5800 Uživatelský manuál
(62 stránky)
(62 stránky)
Brány / ovladače Avaya BSG8/12 1.0 Instalační manuál
(66 stránky)
(66 stránky)
Brány / ovladače Avaya BCM50 Průvodce konfigurací
(35 stránky)
(35 stránky)
Brány / ovladače Avaya B5800 Oznámení
(18 stránky)
(18 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.022 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce