Avaya BayRS 14.0.3.18 Revision Notes Uživatelský manuál stáhnout pdf (Strana 5)

Q00510064-01: VRRP

VRRP may fault during initialization due to a timing issue

between the dependant processes on the router.

===============================================================

BayRS Version 14.0.3.9 corrects the following problem:

===============================================================

Q00470890: RIP

When RIP is configured on an ATM PVC, the router will only send

2-3 update packets per second. As a result, it can take a

significant amount of time to update the entire routing table

on a large network.

================================================================

BayRS Version 14.0.3.8 corrects the following problems:

================================================================

Q00245641: TI_INIT

The TI_INIT process does not release memory on FRE4 and ARE

modules when the Serial Port ModemEnable attribute is enabled.

If many login requests are made, this could eventually cause an

out of memory fault on the router.

Q00391307-02: Radius

When Radius is enabled, if an invalid login attempt is made,

the router logs a message that an invalid radius access response

packet was received and disables the Radius server rather than

sending an access reject packet.

Q00413482: SNMP

When an SNMP get request packet is received with an incorrect

checksum and also has both the More bit and Do Not Fragment bit

set, the router may fault.

================================================================

BayRS Version 14.0.3.7 corrects the following problems:

================================================================

Q00043378-02: IP

The router will fault when one of the four serial interfaces

changes from a down state to an active state while BGP routes

are downloading to the router.

Q00075870: DLSw

When in a redundant path environment, a DLSw connection may be

left in an inconsistent connected state after the router attempts

and fails to make a connection.

Q00137521: IP traffic filter

Configuring IP user defined traffic filters where the user data

offset is greater than the size of the smallest IP packet that

the interface receives (such as an OSPF hello or RIP update)

will cause a fault on an ARE module.

1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře

Avaya BayRS 14.0.3.18 Revision Notes Uživatelský manuál Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya BayRS 14.0.3.18 Revision Notes