Avaya Business Secure Router 252 Configuration - Basics Uživatelský manuál stáhnout pdf (Strana 106)

106 Chapter 6 LAN screens

NN47923-500

Table 16 describes the fields in Figure 24.

Table 16 IP Alias

Label Description

IP Alias 1,2 Select the check box to configure another LAN network for the

Business Secure Router.

IP Address Enter the IP address of your Business Secure Router in dotted

decimal notation.

IP Subnet Mask Your Business Secure Router automatically calculates the subnet

mask based on the IP address that you assign. Unless you are

implementing subnetting, use the subnet mask computed by the

Business Secure Router.

RIP Direction With RIP (Routing Information Protocol, RFC 1058 and RFC 1389),

a router can exchange routing information with other routers. The

RIP Direction field controls the sending and receiving of RIP

packets. Select the RIP direction from Both/In Only/Out Only/

None. When set to Both or Out Only, the Business Secure Router

broadcasts its routing table periodically. When set to Both or In

Only, it incorporates the RIP information that it receives; when set

to None, it does not send any RIP packets and ignores any RIP

packets received.

RIP Version The RIP Version field controls the format and the broadcasting

method of the RIP packets that the Business Secure Router sends

(it recognizes both formats when receiving). RIP-1 is universally

supported but RIP-2 carries more information. RIP-1 is probably

adequate for most networks, unless you have an unusual network

topology. Both RIP-2B and RIP-2M sends the routing data in RIP-2

format; the difference being that RIP-2B uses subnet broadcasting

while RIP-2M uses multicasting. Multicasting can reduce the load

on nonrouter machines because they generally do not listen to the

RIP multicast address and so do not receive the RIP packets.

However, if one router uses multicasting, then all routers on your

network must use multicasting, also. By default, RIP direction is set

to Both and the Version set to RIP-1.

Apply Click Apply to save your changes to the Business Secure Router.

Reset Click Reset to begin configuring this screen afresh.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 459 460

Žádné komentáře

Avaya Business Secure Router 252 Configuration - Basics Uživatelský manuál Strana 106