
Configuring DLSw Services
6-8
Configuring Default Priority Queues
You configure the default behavior of DLSw protocol prioritization using the
Global DLSw PP Parameters/Defaults window. Use this window to enable,
disable, or change the default configuration of priority queues for configured and
unconfigured DLSw peers.
This section shows how to
• Enable the default priority queues for all configured DLSw peers
• Enable the default priority queues for unconfigured peers
• Customize the default priority queue configuration
Note: The steps in this section assume that DLSw is already configured on an
interface and that the Peer Table is complete. For information about
configuring a circuit with DLSw and setting the slot, peer, and SAP
parameters, refer to earlier chapters.
Komentáře k této Příručce