Avaya Configuring PPP Services Uživatelský manuál stáhnout pdf (Strana 56)

Configuring PPP Services

3-2

308639-14.00 Rev 00

Enabling PPP on an Interface

If you have already enabled PPP on the circuit that you want to configure, go to

“Setting Up Remote Addresses

” on page 3-4. If you haven’t already done so, you

must enable PPP on the interface. To do this, refer to Chapter 1.

By default, the protocol that you selected when you first configured this interface

is enabled. If you want to enable a different protocol, you can do so as part of the

customization. BCC supports only IP.

Using the BCC

To enable IP routing on a given interface, navigate to the IP prompt and enter:

state enable

Enabling IPv6 on This Interface 3-10

Specifying the Type of Connection - PPP Mode 3-11

Configuring Data Encryption 3-13

Disabling Network Control Protocols 3-14

Customizing PPP Lines 3-15

Editing PPP Line Parameters 3-15

Enabling Link Control on a Line 3-17

Setting Transmission Parameters 3-18

Customizing PPP Authentication Parameters 3-25

Setting Up Link Quality Monitoring 3-33

Specifying the Asynchronous Modem Control Character Map 3-37

Disabling Loopback Checking 3-39

Setting the Maximum Receive Unit (MRU) 3-40

Disabling RFC 1661 Compliance 3-42

Viewing Line Statistics for Multilink Circuits 3-43

Where to Go Next 3-45

Topic Page

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 151 152

Žádné komentáře

Avaya Configuring PPP Services Uživatelský manuál Strana 56