
Avaya Media Processing Server Series System Reference Manual
Page 156 # P0602477 Ver: 3.1.11
# Available parameters
# ====================#
# discguard 5s - 10m, or 0 to disable (Default 5m)
# The maximum time CCM will wait for all outstanding responses to be received
# before it will force the reset/disconnect sequence to complete
#
# firstsil 0ms - 20400ms (Default 0ms)
# Sets the amount of silence required to abort a record on first silence
# detection (before voice starts). This parameter only applies to synchronous
# recordings.
#
# intersil 0ms - 20400ms (Default 0ms)
# Sets the amount of silence required to automatically abort a recording at
# the end of voice. This parameter only applies to synchronous recordings
#
# rsrcallocguard 0s - 86400s (Default is 1s)
# Specifies the time that TMS should wait for a resource to become available
# during a request by CCM to add a resource to its RSET.
#
# silstrip 0ms - 20400ms (Default 0ms)
# Sets the minimum amount of silence required before the DSP will start
# stripping the silence from the recording. This parameter only applies
# to synchronous recordings
#
# silthresh 0 - 63750 (Default 32)
# Sets the minimum amount of noise needed to distinguish between silence and
# non-silence for a recorder. This parameter only applies to synchronous recordings.
#
# ttstrip >= 0ms (Default 100ms)
# The number of milliseconds of data to strip from the end of a recording
# that is terminated by a touch tone. This parameter only applies to
# synchronous recordings
#
# setsvcparam discguard=5m
#
# recmode <mode>
#
# Sets the mode of recording that will be used (i.e., Disk based or Network based).
# This parameter affects both synchronous and asynchronous recordings.
# Available values for <mode> are DISK or NETWORK.
# Default = NETWORK
#
# NOTE: This parameter can not be set from vsh console or by the application,
# it can only be set during configuration.
#
# recmode NETWORK
Example: ccm_admin.cfg Sheet 2 of 2
Komentáře k této Příručce