Avaya Synchronous Net Modules in an ASN Platform Uživatelský manuál stáhnout pdf (Strana 28)

Installing Synchronous Net Modules in an ASN Platform

Installing a Net Module8 BNX Software Version <x.x> Test Part Number

Installing a Net Module

Before you install the net module, note that

• To access position 2 or 4, you must remove the ﬁller bracket and net module

(if any) above it. See the earlier sections “Removing Filler Brackets” and

“Removing a Net Module.”

• To install a net module in a position from which you just removed a net

module of a different type, you must ﬁrst delete the old net module from the

router’s conﬁguration ﬁle. Then install the new module in the chassis. See

Conﬁguring Routers for information.

To install a net module:

1. Align the slots in the module bracket with the metal tabs in the net

module position that you want to use (Figure 1-5).

Do not rest the module bracket on the metal tabs; doing so makes it difﬁcult to

align the module connector with the connector on the system board.

2. Align the module connector with the connector on the system board.

Make sure that the white retaining post on the system board aligns

through the hole in the net module (Figure 1-5).

3. Firmly press the handle on the net module so that the net module is

secure in its connector on the system board. Make sure that the white

retaining tab snaps into place.

4. Press down on the module bracket so that it rests on the metal tabs.

Note: If you accidentally turn the white retaining post on the system board, it

will not align through the hole in the net module. In this case, turn the post so

that its rectangular base is perpendicular to the net module connectors on the

system board.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 71 72

Žádné komentáře

Avaya Synchronous Net Modules in an ASN Platform Uživatelský manuál Strana 28