Avaya Configuring IP Multicasting and Multimedia Services Uživatelský manuál Strana 213

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 234
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 212
Site Manager Parameters
303527-A Rev. 00
A-43
DVMRP-Specific Announce Policy Parameters
Use the following descriptions to set DVMRP-specific announce policies.
Parameter: Filtered Circuits
Path: Configuration Manager > Protocols > IP > Policy Filters > DVMRP >
Announce Policies
Default: An empty list
Options: Leave empty or specify one or more 2-octet circuit numbers.
Function: This is a list of DVMRP circuits. By specifying a circuit in this list, the filter
applies to DVMRP advertisements sent using that circuit.
Instructions: If you want this filter to apply to any outbound DVMRP circuit, do not
specify any value for this parameter.
If you want this filter to apply to specific outbound DVMRP circuits, specify
the circuit numbers in 2-octet strings.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.16.1.22
Parameter: Filtered Tunnels
Path: Configuration Manager > Protocols > IP > Policy Filters > DVMRP >
Announce Policies
Default: An empty list
Options: Leave empty or specify one or more 8-octet IP addresses.
Function: This is a list of DVMRP tunnels. If a tunnel interface appears in this list the
filter applies to DVMRP advertisements sent via that tunnel. Each tunnel
takes 8 octets, the first 4 of which are for the local IP address and the last 4
are for the remote IP address.
Instructions: If you want this filter to apply to any DVMRP tunnel, do not specify any
value for this parameter.
If you want this filter to apply to specific DVMRP tunnels, specify the IP
addresses in 8-octet strings. Entering all Fs for the first IP address turns off
this filter.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.16.1.23
Zobrazit stránku 212
1 2 ... 208 209 210 211 212 213 214 215 216 217 218 ... 233 234

Komentáře k této Příručce

Žádné komentáře