Avaya Configuring IP Utilities Uživatelský manuál stáhnout pdf (Strana 25)

Starting IP Utilities

308631-14.00 Rev 00

1-3

•

slot_number

is the number of the slot in which the link or net module is

located.

•

module_number

is the net module number (ASN

™

and System 5000

™

routers

only).

•

connector_number

is the number of a connector on the link or net module.

For example, the following command configures an Ethernet interface on slot 2,

connector 2:

box# ethernet slot 2 connector 2

ethernet/2/2#

Step 2: Configuring an IP Interface

To configure an IP interface on a physical interface, navigate to the prompt for the

physical interface and enter:

ip address <

address>

mask <

mask>

address

and

mask

are a valid IP address and its associated subnet mask, expressed

in either dotted-decimal notation or in bit notation.

For example, the following command configures IP interface 2.2.2.2/255.0.0.0 on

an Ethernet physical interface on slot 2, connector 2:

ethernet/2/2# ip address 2.2.2.2 mask 255.0.0.0

ip/2.2.2.2/255.0.0.0#

An IP interface is now configured on the Ethernet interface with default values for

all interface parameters. When you configure an IP interface, the BCC also

configures IP globally on the router with default values for all IP global

parameters.

Using Site Manager

Before you can select a protocol to run on the router, you must configure a circuit

that the protocol can use as an interface to an attached network. For information

and instructions, see Configuring WAN Line Services and Configuring Ethernet,

FDDI, and Token Ring Services.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 227 228

Komentáře k této Příručce

Žádné komentáře

Avaya Configuring IP Utilities Uživatelský manuál Strana 25

Komentáře k této Příručce

Související produkty a manuály pro Software Avaya Configuring IP Utilities