Avaya Configuring IP Utilities Uživatelský manuál stáhnout pdf (Strana 26)

Configuring IP Utilities

1-4

308631-14.00 Rev 00

When you have successfully configured the circuit, the Select Protocols window

opens. Proceed as follows:

Starting TCP Services

You can use the BCC or Site Manager to start TCP on the router, accepting default

values for all parameters. If you decide to change some or all of the default values,

see Chapter 3, “Customizing TCP Services.”

Before you begin, verify that you configured IP on an interface. For instructions,

see “Configuring IP for Global Protocols

” on page 1-2.

Using the BCC

To configure TCP on the router with default settings, begin in configuration mode

at the box or stack prompt:

Go to the global IP prompt.

box#

ip#

Configure TCP.

ip#

tcp

Site Manager Procedure

You do this System responds

1. In the Select Protocols window, select

Then click on

The IP Configuration window opens.

2. Set the following parameters:

•

IP Address

•

Subnet Mask

•

Transmit Bcast Addr

•

UnNumbered Assoc Address

Click on

Help

or see the parameter

descriptions in

Configuring IP, ARP, RARP,

RIP, and OSPF Services

3. Click on

. Site Manager displays a window asking if

you want to enable TFTP on the router.

4. Click on

Yes

to enable TFTP. Otherwise,

click on

You return to the Configuration Manager

window.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 227 228

Komentáře k této Příručce

Žádné komentáře

Avaya Configuring IP Utilities Uživatelský manuál Strana 26

Komentáře k této Příručce

Související produkty a manuály pro Software Avaya Configuring IP Utilities