Avaya Hardware Compression Net Modules in ASN Platforms Uživatelský manuál stáhnout pdf (Strana 30)

Installing Hardware Compression Net Modules in ASN Platforms

1-8 115374-A Rev. A

Installing a Net Module

To install a net module:

1. Align the slots at each end of the module bracket with the metal tabs in

the net module position that you want to use (Figur

e 1-5).

Do not rest the module bracket on the metal tabs; doing so makes it difﬁcult to

align the module connector with the connector on the system board.

2. Align the module connector with the connector on the system board.

Make sure that the white retaining post on the system board goes through

the hole in the net module (Figur

e 1-5).

3. Firmly press the handle on the net module so that the net module is

secure in its connector on the system board. Make sure that the white

retaining tab snaps into place.

4. Press down on the module bracket so that it rests on the metal tabs.

Note: To install a net module in a position from which you just removed a net

module of a different type, you must ﬁrst delete the old net module from the

router’s conﬁguration ﬁle. Then install the new module in the chassis. For

information, refer to Conﬁguring Routers if you use router software or

Administration Guide if you use BayStream software.

Note: If you accidentally turn the white retaining post on the system board, it

will not go through the hole in the net module. In this case, turn the post so that

its rectangular base is perpendicular to the net module connectors on the

system board.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Žádné komentáře

Avaya Hardware Compression Net Modules in ASN Platforms Uživatelský manuál Strana 30