Avaya Configuring Dial Services Uživatelský manuál Strana 128

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 428
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 127
Configuring Dial Services
4-20 114062 Rev. B
Using the ping Command for ISDN Connections
To check the availability of a remote device in an ISDN network, you can use the
ping command. The ping command sends an Internet Control Message Protocol
(ICMP) echo request to a remote address that you specify. You can issue this
command using Site Manager’s Administration option, Ping from Router, or by
using the Technician Interface.
Call setups for dial connections require more time than setups for ISDN
connections. When you ping a remote device using the default timeout value, 5
seconds, it may fail because the router does not wait long enough for a response
from the remote device. Therefore, you may want to increase the timeout value so
the router will allow enough time for a response.
For information about using the
ping command, refer to Managing Routers and
BayStream Platforms. For information about using the Technician Interface, refer
to Using Technician Interface Software.
Zobrazit stránku 127
1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 427 428

Komentáře k této Příručce

Žádné komentáře