
Configuring Dial Services
1-28 114062 Rev. B
Creating Bandwidth Circuits
There are two ways to enable bandwidth-on-demand service: designate a single
leased circuit or a leased multilink circuit as a bandwidth-on-demand circuit, or
assign a bandwidth pool to a demand circuit. If these circuits become congested,
the router provides up to 29 dial-up circuits to relieve the congestion, for a total of
30 dial-up lines for communication.
For configuration instructions, refer to the next section for leased circuits or to
“Adding Bandwidth
Service for Demand Lines” on page 1-33.
Configuring Leased Circuits as Bandwidth Circuits
You should have already configured PPP multilink for the leased circuits that you
will designate as bandwidth circuits.
To configure leased circuits as bandwidth circuits:
1. Begin at the Configuration Manager window (refer to Figure 1-1).
2. Select Dialup > Bandwidth On Demand Circuits.
Site Manager displays the Bandwidth-On-Demand Circuit Definition window
(Figure
1-22), which lists the leased circuits that you previously configured.
Komentáře k této Příručce