Avaya Configuring Ethernet, FDDI, and Token Ring Services Uživatelský manuál stáhnout pdf (Strana 87)

Site Manager Parameters

305259-A Rev 00

A-3

Parameter: BofL Timeout

Path: Configuration Manager > XCVR Connector > Edit Line > Edit CSMA/CD

Parameters

Default: 5 (4 if router redundancy is enabled)

Options: 1 to 60 seconds

Function: Specifies the time between transmissions of Breath of Life messages from this

Ethernet interface. Timeout will occur if five periods elapse without a successful

BofL message transmission. When timeout occurs, the router disables and

reenables the Ethernet interface.

This parameter is valid only if you set BofL Enable to Enable.

Instructions: Accept the default BofL timeout of 5 seconds, or specify a new value up to 60

seconds.

MIB Object ID: 1.3.6.1.4.1.18.3.4.1.1.8

Parameter: Hardware Filter

Path: Configuration Manager > XCVR Connector (10BASE-T only) > Edit Line >

Edit CSMA/CD Parameters

Default: Disable (the default changes to Enable when, while adding the circuit, you reply

OK to the prompt:

Do you want to enable Hardware Filters on this circuit?)

Options: Enable

Disable

Function: Enables filtering hardware in the link or net module to drop local frames at the

interface instead of copying them into system memory. Enabling hardware

filters improves bridging software performance because router resources are not

used to receive and reject local frames.

Instructions: Set to Enable only if you enabled the bridge software and the link or net module

has hardware filters.

MIB Object ID: 1.3.6.1.4.1.18.3.4.1.1.29

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 135 136

Žádné komentáře

Avaya Configuring Ethernet, FDDI, and Token Ring Services Uživatelský manuál Strana 87