
Configuring Line Services
8-6 114078 Rev. A
Configuring the LRM
When you activate the LRM, you must
1. Specify an estimated bandwidth value greater than 0.
2. On a multiline circuit, edit the Multiline Select Algorithm and Multiline
Threshold Bandwidth parameters.
You may also want to
1. Modify or verify the default queuing of traffic for reserved bandwidth.
Specify the Traffic Queuing Algorithm, Policing Algorithm, Bandwidth
Interval, and Inflate Reservations Percentage.
2. Modify or verify the default queuing of traffic for unreserved bandwidth.
Specify the Unreserved Policing Algorithm and Unreserved Queue Length.
3. Modify or verify the maximum latency for a reserved-flow packet.
Set the Reservation Latency.
See the applicable sections to configure LRM on an interface:
•
Setting the Estimated Bandwidth
•
Setting the Reservable Bandwidth
•
Specifying the Traffic Queuing Algorithm
•
Specifying the Policing Algorithm
•
Setting the Bandwidth Interval
•
Setting the Inflate Reservations Percentage
•
Specifying the Unreserved Policing Algorithm
•
Specifying the Unreserved Queue Length
•
Specifying the Multiline Select Algorithm
•
Setting the Multiline Threshold Bandwidth
•
Setting the Reservation Latency
Komentáře k této Příručce