Avaya Configuring MPLS Services Uživatelský manuál Strana 74

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 92
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 73
Configuring MPLS Services
A-4
305754-A Rev 00
Parameter: Remote TCP Port
Path: Configuration Manager > Circuits > Edit Circuits > Edit > MPLS > LDP
Default: 8192
Options: 1 to 65535
Function: S
pecifies the remote TCP port number of the label-switching router (LSR) that
the label edge router (LER) uses to establish the TCP connection.
Instructions:
Accept the default, 8192, or enter a TCP port number from 1 to 65,535.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.15.1.1.9
Parameter: Routes Configuration Mode
Path: Configuration Manager > Circuits > Edit Circuits > Edit > MPLS > LDP
Default: AUTO
Options: AUTO
|
MANUAL
Function: S
pecifies what kind of route table LDP uses. When you accept the default, Auto,
MPLS uses either the OSPF or RIP route table. When you specify Manual, LDP
uses static routes.
Instructions: Accept the default, AUTO, if you want MPLS to configure routes using OSPF
or RIP. Specify MANUAL if you want MPLS to use static routes.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.15.1.1.10
Note:
The routes configuration mode takes precedence over the protocol that
you set (see
Protocol” on page A-5). This means that when you set the routes
configuration mode to Manual, LDP disregards the protocol setting.
Zobrazit stránku 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 91 92

Komentáře k této Příručce

Žádné komentáře