Avaya ATM Link Modules and Routing Engines in BN Platforms Uživatelský manuál stáhnout pdf (Strana 24)

Installing ATM Link Modules and Routing Engines in BN Platforms

1-6

114951-B Rev 00

Inserting the Link Module

Insert the link module in the BLN, BLN-2, or BCN platform as follows:

Attach an antistatic wrist strap.

BN platforms and link modules ship with an antistatic wrist strap. You must

wear one of these straps whenever you access components in a platform.

The antistatic wrist strap directs the discharge of static electricity from your

body to the chassis, thereby avoiding discharge and possible damage to

sensitive electronic components.

Using the slot card guides, slide the module into the appropriate slot until

the module’s connector panel touches the BN platform’s back panel.

Refer to Figure 1-1 (BLN), 1-2 (BLN-2), or 1-3 (BCN) in Chapter 1 for slot

locations.

Secure the captive screw on each end of the module (Figure 1-5).

Figure 1-5

shows the captive screws on an ARE E-3 link module; however,

these screws are the same on all link modules.

Table 1-1. ARE DS-3 and ARE E-3 Jumper Settings

Option Setting Jumper

Chassis ground connection for

BNC transmit interface

Connected

Disconnected

Chassis ground connection for

BNC receive interface

Connected

Disconnected

Caution:

Electrostatic discharge can damage hardware. Always use the

antistatic wrist strap when handling any component in the BN platform.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

Žádné komentáře

Avaya ATM Link Modules and Routing Engines in BN Platforms Uživatelský manuál Strana 24