Avaya Configuring BayStack Remote Access Uživatelský manuál Strana 107

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 140
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 106
Troubleshooting Network Boot Problems
308614-14.00 Rev 00
B-11
The following sample response shows the default settings for an AN/ANH with
one Ethernet interface and two synchronous interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
XCVR1..None
COM1...EZ-Install
COM2...EZ-Install
The following sample response shows the settings for an ARN with one Ethernet
interface, one token ring interface, and five synchronous interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...EZ-Install
COM2...EZ-Install
COM3...EZ-Install
COM4...EZ-Install
COM5...EZ-Install
The possible settings for boot image and boot config are network and local. If
the setting is
network, the BayStack router requests the kernel file or
configuration file from a BootP server when booting. If the setting is
local, the
BayStack router uses the kernel file or configuration file stored in flash memory.
The
XCVR parameter shows the current setting of the Ethernet connectors. The COM
parameters show the current settings of the synchronous connectors. The MAU
parameter shows the setting of the token ring connectors (ARN only).
Zobrazit stránku 106
1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 139 140

Komentáře k této Příručce

Žádné komentáře