Avaya Configuring BayStack Remote Access Uživatelský manuál stáhnout pdf (Strana 37)

Understanding Tools and Options

308614-14.00 Rev 00

1-19

EZ-Install

Complete the following steps for the EZ-Install option:

Use the Configuration Manager in local mode to create a complete

configuration file for the BayStack router. (See Chapter 3 and Configuring

and Managing Routers with Site Manager.)

Set up a UNIX workstation on the network to support BootP. (See Chapter 2.)

Create a BootP client on the upstream router to support automated addressing,

and configure all routers between the BootP server and the BayStack router as

BootP relay agents. (See Chapter 3.)

Ensure that there is a network connection from a synchronous interface on the

BayStack router to the upstream router.

A person at the BayStack router site installs and turns on the router. (See the

model-specific hardware installation guide.)

The BayStack router obtains a software image from its local file system, an IP

address from the upstream router, and the customized configuration file from

the BootP server. (“The Boot Process

” on page 1-5 describes this process; no

action is required.)

If the configuration file meets your network requirements, the BayStack

router starts bridging and routing traffic.

Use the Site Manager Statistics Manager and Events Manager tools to verify

that the BayStack router is routing traffic as specified in the configuration file.

(See Configuring and Managing Routers with Site Manager.)

Note:

If the BayStack router will connect to the upstream router over a frame

relay circuit, ensure that the upstream router is running BayRS Version 7.80 or

later.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 139 140

Žádné komentáře

Avaya Configuring BayStack Remote Access Uživatelský manuál Strana 37