Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Uživatelský manuál Strana 101

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 190
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 100
303509-A Rev 00 7-1
Chapter 7
Configuring the Layer 3 Gateway
Only Layer 3 tunnels use a gateway. To configure a Bay Networks router at the
service provider site as a Dial VPN gateway, you can use Site Manager to create a
local or dynamic configuration file to configure the software for the gateway.
Configuring the Gateway
The following example shows how to configure an ASN platform, but the
principles are the same for other Bay Networks routers. For more information
about configuring your router, see Configuring and Managing Routers with Site
Manager and your platform-specific guides.
1.
Using Site Manager, select the module and slot that you want to
configure.
2.
Add the circuit that you are configuring on that interface.
3.
Select frame relay or PPP as the WAN protocol in the WAN Protocols
window.
This enables frame relay or PPP on the interface you just selected. You can
customize frame relay later to suit your system’s requirements.
4.
Select DVS as the Layer 3 protocol in the Select Protocols window.
This automatically selects IP as well. By default, RIP is not selected.
Note:
You can dynamically configure the gateway, then save the configuration
file, or you can alter or create a configuration file and boot the gateway from it.
Zobrazit stránku 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 189 190

Komentáře k této Příručce

Žádné komentáře