Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Uživatelský manuál Strana 38

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 190
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 37
Configuring and Troubleshooting Bay Dial VPN Services
2-4 303509-A Rev 00
The CPE router that is the end point of Layer 2 tunnels is configured as
the LNS and is configured with a frame relay or PPP connection to the
ISP network (including a static route and an adjacent host if the CPE
router is not a Cisco device).
For instructions on configuring the LNS, see Configuring L2TP Services.
Any shared information, such as passwords, secrets,” or phone numbers,
is consistent across the link.
9.
Individually test each network component, then test the entire system.
L2TP Packet Encapsulation
The dial-in user sends PPP packets to the LAC, which encapsulates these
incoming packets in an L2TP packet and sends it across an IP network through a
bidirectional tunnel. After the LNS receives the packets, it decapsulates them and
terminates the PPP connection.
Figure 2-2
shows how data is encapsulated for transmission over an L2TP tunnel.
Zobrazit stránku 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 189 190

Komentáře k této Příručce

Žádné komentáře