Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Uživatelský manuál Strana 86

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 190
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 85
Configuring and Troubleshooting Bay Dial VPN Services
5-10 303509-A Rev 00
acctp
=<
accounting_protocol>
Specifies the accounting protocol used
between the gateway and the
accounting server. The only valid value
is
radius
. Specify
none
to disable
accounting.
If you specify radius, you must also
specify a primary server.
Required for
add
and
modify
. Not used for
other commands.
addrp
=<
dynamic_address_
allocation_protocol>
Specifies the dynamic address
allocation protocol used between the
gateway and the dynamic address
allocation server. Specify
dhcp
to
enable dynamic allocation or
none
to
disable it.
If you specify this protocol, you must
also specify a primary server.
Required for
add
and
modify
. Not used for
other commands.
spi
=<
security_protocol_index>
tatype
=<
tun_auth_type>
tamode
=<
tun_auth_mode>
takey
=<
tun_auth_key>
spi
defines an identifier in the range 256
through 65535 that the gateway uses to
determine the tunnel authentication
type, mode, and key. You must configure
these values on the gateway using Site
Manager, as well as configuring them in
TMS. The default value is 0 (no
authentication).
tatype
is the type of authentication
algorithm used to encrypt tunnel
registration messages between the NAS
and the gateway. This value must be
MD5 encryption.
tamode
is the operating mode of the
authentication algorithm. This value
must be pref-suff (prefix/suffix).
takey
is the key that the authentication
algorithm uses. It can be up to 64
hexadecimal characters (0-9, A-F, a-f) in
length.
spi
is optional for
add
and
modify
. Not used for
other commands.
If you specify
spi
for
tunnel authentication, all
three
ta
arguments are
required for
add
and
modify
.
If you specify the
ta
arguments, you must also
specify the
spi
value. The
spi/takey
combination in
the TMS database must
match the
spi/takey
pair
on the gateway, or the
authentication will fail. It
will look like a bad
password, not an
incorrectly matched
encryption key.
Not used for other
commands.
(continued)
Table 5-2. tms_dbm Command Arguments
(continued)
Argument Function
Used with These
Commands
Zobrazit stránku 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 189 190

Komentáře k této Příručce

Žádné komentáře