Avaya Configuring IP, ARP, RARP, RIP, and OSPF Services Uživatelský manuál stáhnout pdf (Strana 171)

100

101

Customizing RIP Services

308627-14.20 Rev 00

5-27

Table 5-2 lists the parameters and values that you can enter.

For example, the following command sets the state to disabled for RIP accept

policy pol_1:

accept/pol_1/rip#

state disabled

accept/pol_1/rip#

Table 5-2. BCC Definition Parameters for RIP Accept Policies

Parameter Values Function

action ignore

accept (default)

Specifies whether the protocol ignores a route

that matches the policy or forwards the route

to the routing table manager

precedence 0 (default) to any

integer

Assigns a metric value to this policy (a policy

with a higher value takes precedence over a

policy with a lower value). This value

determines the order of precedence for

policies that match the same route.

preference 1 (default) to 16 Assigns a metric value (the higher the

number, the greater the preference) to a route

that the protocol forwards to the routing table

manager. If confronted with multiple routes to

the same destination, the routing table

manager may use this value to decide which

route to insert. Routes for all networks

(0.0.0.0/0.0.0.0) should have the lowest

preference, and routes for the most specific

networks (longest address and mask) should

have the highest preference.

state enabled (default)

disabled

Enables and disables the policy that you

created

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 389 390

Komentáře k této Příručce

Žádné komentáře

Avaya Configuring IP, ARP, RARP, RIP, and OSPF Services Uživatelský manuál Strana 171

Komentáře k této Příručce

Související produkty a manuály pro Software Avaya Configuring IP, ARP, RARP, RIP, and OSPF Services