Avaya Using Technician Interface Software Uživatelský manuál stáhnout pdf (Strana 177)

System Administration

308657-14.00 Rev 00

7-41

Configuring NTP Using the Technician Interface

When you use the Technician Interface to configure the Network Time Protocol

(NTP), you must configure NTP on each slot on the router to ensure that NTP

initializes correctly.

You can configure NTP on each slot by setting the following MIB variable from

the Technician Interface:

set wfProtocols.68.0 0xffffffff;commit

68 represents the wfNTPLoad attribute.

Assigning Passwords

This section describes how to assign or reassign the Manager and User access

passwords.

The Technician Interface runs on a single processor module. When you assign a

password, the GAME operating system distributes the new password to

nonvolatile RAM in all processor modules. (For this reason, the system retains

passwords if the Technician Interface runs subsequently on a different processor

module, after you booted the router, reset a slot, or replaced a board.)

You can assign the User access password when you are logged in as User or

Manager. You can assign the Manager access password only when you are logged

in as Manager.

Note:

If you insert a new processor module, you must reassign the Manager

and User passwords; otherwise, the Technician Interface will not require

passwords when it runs on that slot.

Note:

Passwords, as well as Technician Interface commands and file names,

are case-sensitive.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 343 344

Žádné komentáře

Avaya Using Technician Interface Software Uživatelský manuál Strana 177