Avaya Using Technician Interface Software Uživatelský manuál stáhnout pdf (Strana 307)

Using Syslog Messaging to Monitor Router Events

308657-14.00 Rev 00

C-19

Define a severity mask

only

if you did not already define an event

number (or event number range). If you defined an event number or

number range, Syslog ignores any severity mask for this filter.

To define by severity levels the event messages you want Syslog to select

and forward to a specific remote host, enter the following:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSevMask.

<host_IP_address>.<entity_code>.<filter_index>

“

<fwitd>”

$: commit

To also define by slot number(s) the event messages you want Syslog

to select and forward to a specific remote host, enter the following:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSlotLowBnd.

<host_IP_address>.<entity_code>.<filter_index>

<0 - 14>

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSlotLowUpp.

<host_IP_address>.<entity_code>.<filter_index>

<0 - 14>

$: commit

Define how router event message severity levels and UNIX system error

levels map to one another.

In most cases, you accept the default mapping and go to Task 7. Otherwise,

continue with the following instructions to customize the message mapping.

Enter at the Technician Interface prompt the command line(s) appropriate for

the message mapping(s) you want to change:

• Change router FAULT message mapping, as follows:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrFaultMap.

<host_IP_address>

<entity_code>

<filter_index>

<1 - 8>

The default value of wfSyslogEntFltrFaultMap is 3, mapping router

FAULT level messages to UNIX system level CRIT messages.

• Change router WARNING message mapping, as follows:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrWarningMap.

<host_IP_address>

<entity_code>

<filter_index>

<1 - 8>

Note:

Although the valid range for the slot lower and upper boundaries is 0 to

14, specify only values within the range of actual slot numbers for the router

model you are configuring. Otherwise, the filter will not transition to an active

state.

1 2 ... 302 303 304 305 306 307 308 309 310 311 312 ... 343 344

Komentáře k této Příručce

Žádné komentáře

Avaya Using Technician Interface Software Uživatelský manuál Strana 307

Komentáře k této Příručce

Související produkty a manuály pro Software Avaya Using Technician Interface Software