Avaya BCM 2.0 Programming Uživatelská příručka stáhnout pdf (Strana 101)

100

101

Configuring Enterprise Edge Services 101

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

6. Click a Facility value: Use line nnn, Use prime line, Pool code, Use routing

table.

Note: For Pool, type a letter from A to O and then press Enter. For Use line,

type a number from 001 to 238, and then press Enter. You cannot use

Target lines as the facility.

ATA settings

The ATA settings allow you to define general settings for analog terminal adapters.

To configure ATA settings:

1. Choose Services, Telephony Services, Terminals & sets.

2. Click the telephone set (DN 221-528).

3. Choose Capabilities.ClickontheATA settings heading.

4. Configure ATA settings according to the table:

Attribute Description

ATA answer

timer

Select the length of delay between the last digit you dial and when the

Enterprise Edge ATA 2 device is ready to receive DTMF tone.

Values: 3, 5, 7, 10 (Default: 7)

ATA use Select the location of the Enterprise Edge ATA 2.

Values: On site, Off site (Default: Off site)

Msg Indicate Select the type of message indicator. Tone sends a Message Tone through

the set’s receiver and Lamp turns on the set’s Message Lamp when you

receive a message.

Values: None, Tone, Lamp (Default: None)

Tips

If you have a modem or fax machine keep the ATA answer timer delay short.

If a call to a fax machine or modem cannot connect, try shortening the delay. If

an individual is dialing the number for a fax machine or modem, you may want

to make the delay a little longer.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 445 446

Komentáře k této Příručce

Žádné komentáře

Avaya BCM 2.0 Programming Uživatelská příručka Strana 101

Komentáře k této Příručce

Související produkty a manuály pro Brány / ovladače Avaya BCM 2.0 Programming