Avaya BCM 2.0 Programming Uživatelská příručka Strana 286
- Strana / 446
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
286 Maintenance
Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01
Eachevent hasa severity number.An“S” preceding this number, “S4” forexample,
may appear in the event message. “S9” is the most severe. If the log is full, new
event messages with a higher severity number replace existing event messages of a
lower severity. For this reason, you should check event messages at regular
intervals. You can then deal with all messages before they are replaced. The time
that the message is recorded is also provided.
Event message information that is specific to Companion components is included
in the Companion event messages (North American systems only) on page 291.
For every event message that you see:
1. Refer to Significant event messages on page 286.
2. Determine if the event caused the system to automatically restart. For more
information, refer to the table on Event Message on page 289.
Significant event messages
The following table lists event messages that are relevant to maintenance activities.
Event message The event message is recorded when…
Evt:210-YYYZ S4 Loopback test YYY on Trunk module Z has been started
Evt:211-YYYZ S4 Loopback test YYY on Trunk module Z has been stopped
Evt:220-3546 S4 the Sys admin log has been cleared by the DN (3546 in this
case)
Evt:221-3546 S4 the Sys test log has been cleared by the DN (3546 in this case)
Evt:222-3546 S5 the DN (3546 in this case) enters the debugging facility that is
password protected
Evt:255 S9 administered mode is notsupported by the module plugged into
the slot
Evt:260-0302 S8 the system takes the access line on port 0302 out of service
because no current was detected
Evt:261-0302 S1 the access line on port 0302 is returned to service after current
was detected (see Evt:260)
Evt:268-07 S8 Dialing filter 07 has lost data due to a fault in the system
memory
Evt:269-3546 S8 the Line/set filter for the DN (3546 in this case) has lost data
due to a fault in the system memory
Evt:299 S1 the system powers up after a power failure
Evt:327 S5 short term alarm threshold has been surpassed in the EE-DTM
Evt:328 S5 short term alarm threshold has been surpassed in the EE-DTM
Evt:329 S5 short term alarm threshold has been surpassed in the EE-DTM
Evt:330 S5 short term alarm threshold has been surpassed in the EE-DTM
Evt:336 S5 long term alarm has been surpassed in the EE-DTM
Evt:373 S5 the system restart diagnostic tool has been activated
Evt:407 S2 there are no more codes for Speed Dial numbers
Evt:408 S2 there is no more memory for Speed Dial codes
- Enterprise Edge 2.0 1
- Programming Operations 1
- Contents 3
- 4 Contents 4
- Contents 5 5
- 6 Contents 6
- Contents 7 7
- 8 Contents 8
- Contents 9 9
- 10 Contents 10
- Contents 11 11
- Glossary 395 12
- Index 437 12
- About this document 13
- Related documents 14
- Regulations 15
- Enhanced 911 Configuration 16
- Radio-frequency interference 16
- Hearing-aid compatibility 17
- Electromagnetic compatibility 17
- Use of a music source 18
- Software licensing 21
- 22 About this document 22
- Enterprise Edge Overview 23
- 24 Enterprise Edge Overview 24
- Enterprise Edge Overview 25 25
- 26 Enterprise Edge Overview 26
- Enterprise Edge Overview 27 27
- Unified Manager 28
- Enterprise Edge Overview 29 29
- Enterprise Edge Overview 31 31
- Enterprise Edge Overview 33 33
- 34 Enterprise Edge Overview 34
- Logging on to Enterprise Edge 37
- Logging off Enterprise Edge 40
- Configuring system settings 41
- System registration 42
- To view LAN performance: 49
- Frame Relay 50
- Point-to-Point-Protocol (PPP) 50
- WAN Data Compression 50
- Parameters: 55
- Configuring a 59
- Net Link 59
- Deleting an ISDN interface 63
- Media Services Card 66
- Media Bay Modules 69
- Media Bay Modules (cont’d) 70
- Provision lines 81
- Programming order 83
- Programming Services 84
- Viewing all Services 85
- Statuses 86
- Telepho ny Ser vices 87
- Terminals & sets 90
- Line access 93
- OLI number 95
- Capabilities 98
- User preferences 102
- Restrictions 103
- Telco features 106
- Control set 109
- Trunk/line data 111
- Line type on page 116 112
- Assigning DNs 123
- Restriction filters 124
- Time & date 127
- Call Routing 128
- Routes and destination codes 129
- Destination codes 131
- Services: Routing Service) 134
- Scheduled Services 138
- Ringing service 139
- Restriction service 141
- Routing Service 142
- Common Settings 143
- System speed dial 145
- General Settings 147
- Feature settings 148
- Park mode on page 150 149
- Call log space 151
- Direct dial 153
- CAP assignment 154
- Private DN lengths 155
- Access codes 156
- Remote access packages 160
- COS Passwords 160
- DN lengths 162
- Network Name Display 163
- (virtual network) 167
- Network Services 169
- Hunt groups 170
- , Hunt groups 171
- Moving members of a group 172
- Setting the Distribution mode 174
- Setting the hunt delay 174
- Programming busy line setting 175
- Queue time-out 175
- Overflow set 175
- Companion 177
- Radio data 179
- Cell assignment 180
- Cell Radios 180
- Register individual portables 181
- Hospitality 183
- Alarm time (AL) feature 184
- Set/room settings 185
- Call permissions 185
- Alarm data 186
- Voice Mail 188
- Call Detail Recording 188
- Console Service 189
- VoIP Gateway 189
- IP Routing 200
- IPX Routing 208
- WAN Overview 222
- 4. Click Save 224
- filters in 226
- QoS monitor 227
- Web cache 228
- Net Link Manager 229
- Alarm Service 232
- IP Firewall Filters 235
- Signalling System1 241
- DPNSS 1 capabilities 242
- DPNSS 1 features 242
- Three Party Service 243
- Diversion 243
- Restrictions by set type 244
- Redirection 245
- Executive Intrusion 245
- Intrusion levels 246
- Call Offer 247
- Route Optimization 248
- Message Waiting Indication 249
- Loop avoidance 252
- User Manager 253
- Alarm Manager 256
- Maintenance 259
- Warm reset 260
- Backup and restore 260
- Maintenance 261 261
- 264 Maintenance 264
- Manager’s Tools menu 265
- 266 Maintenance 266
- 268 Maintenance 268
- Maintenance 269 269
- Maintenance 275 275
- ICMP Counters 275
- 276 Maintenance 276
- UDP Counters 276
- TCP Counters 276
- System version 278
- Media Bay Module status 279
- System test log 282
- System administration log 283
- Network event log 284
- Alarm codes 285
- Event messages 285
- Maintenance 295 295
- CSU statistics 297
- Maintenance 299 299
- 300 Maintenance 300
- Link Status 301
- Moving telephones 302
- 304 Maintenance 304
- Getting ready 306
- Types of problems 306
- Fault Alarm Banner 308
- Problems with telephones 309
- Problems with lines 310
- Problems with external paging 317
- Problems with module service 318
- Dialed number gets busy tone 322
- Dialedfeaturecodegetsbusytone 324
- Services 325
- Appendix A: Network Examples 327
- Access using Enterprise Edge 328
- Lines used for networking 328
- PRI lines 329
- BRI lines 330
- Remote access on PRI trunks 332
- Remote access on DPNSS lines 332
- Enterprise Edge security 333
- Coordinated dialing plans 335
- Routing service (continued) 336
- System A 340
- System B 340
- System D 340
- System C 340
- Networking examples 341
- PRI (SL-1) 343
- PRI (public protocol) 343
- (public protocol) 349
- PRI/BRI QSIG 357
- Public networking scenarios 362
- Enterprise Edge 363
- Central Office 363
- Private networking scenarios 365
- PRI DID and 2-way DID 370
- Appendix B: ISDN Overview 371
- Types of ISDN service 372
- ISDN layers 372
- ISDN Bearer capability 373
- PRI services and features 373
- BRI services and features 373
- 374 Appendix B: ISDN Overview 374
- Appendix B: ISDN Overview 375 375
- 376 Appendix B: ISDN Overview 376
- ISDN hardware 377
- BRI hardware 378
- Clock Source for ISDN 379
- ISDN standards compatibility 380
- Planning your ISDN network 380
- Ordering ISDN PRI 381
- Ordering ISDN BRI 381
- Supported ISDN protocols 382
- ISDN programming 383
- 384 Appendix B: ISDN Overview 384
- Appendix B: ISDN Overview 385 385
- Program ISDN equipment 386
- Appendix B: ISDN Overview 387 387
- 388 Appendix B: ISDN Overview 388
- System defaults 392
- Glossary 395
- 396 Glossary 396
- Glossary 397 397
- 398 Glossary 398
- Glossary 399 399
- 400 Glossary 400
- Glossary 401 401
- 402 Glossary 402
- Glossary 403 403
- 404 Glossary 404
- Glossary 405 405
- 406 Glossary 406
- Glossary 407 407
- 408 Glossary 408
- Glossary 409 409
- 410 Glossary 410
- Glossary 411 411
- 412 Glossary 412
- Glossary 413 413
- 414 Glossary 414
- Glossary 415 415
- 416 Glossary 416
- Glossary 417 417
- 418 Glossary 418
- Glossary 419 419
- 420 Glossary 420
- Glossary 421 421
- 422 Glossary 422
- Glossary 423 423
- 424 Glossary 424
- Glossary 425 425
- 426 Glossary 426
- Glossary 427 427
- 428 Glossary 428
- Glossary 429 429
- 430 Glossary 430
- Glossary 431 431
- 432 Glossary 432
- Glossary 433 433
- 434 Glossary 434
- Glossary 435 435
- 436 Glossary 436
- (‡) uses two of 436
- , 153, 157 439
- , 285, 289 445
Související produkty a manuály pro Brány / ovladače Avaya BCM 2.0 Programming
Brány / ovladače Avaya Mobile Communication 3100 Planning and Engineering Uživatelský manuál
(52 stránky)
(52 stránky)
Brány / ovladače Avaya 3.6/SRG Oznámení
(14 stránky)
(14 stránky)
Brány / ovladače Avaya Configuring BayRS Routers and Protocols (308665-14.20 Rev 00) Uživatelský manuál
(26 stránky)
(26 stránky)
Brány / ovladače Avaya VoIP Monitoring Manager Release 3.1 Configuration Uživatelský manuál
(48 stránky)
(48 stránky)
Brány / ovladače Avaya B5800 Uživatelský manuál
(342 stránky)
(342 stránky)
Brány / ovladače Avaya B5800 Oznámení
(12 stránky)
(12 stránky)
Brány / ovladače Avaya Reference for BCC IP show Commands (308603-14.20 Rev 00) Uživatelský manuál
(78 stránky)
(78 stránky)
Brány / ovladače Avaya Business Communications Manager 5.0 - Fault and Performance Management Uživatelský manuál
(70 stránky)
(70 stránky)
Brány / ovladače Avaya IP Telephony Průvodce konfigurací
(146 stránky)
(146 stránky)
Brány / ovladače Avaya Mobile Communication 3100 Planning and Engineering Uživatelský manuál
(54 stránky)
(54 stránky)
Brány / ovladače Avaya 5.0/Business Uživatelský manuál
(156 stránky)
(156 stránky)
Brány / ovladače Avaya BSGX4e Průvodce nastavením
(31 stránky)
(31 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce