Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 Oznámení stáhnout pdf (Strana 21)

Release Notes for BayStack Operating System Switching Software (BoSS) 3.1

• If you add MAC addresses to Security Lists that do not have ports associated

with them, and then display the Security Lists, the lists will appear empty

until a port is associated with the list. (Q00622842)

• A mixed stack may reset twice after being booted or rebooted. This may cause

a slight delay in booting the stack. (Q00617280)

• If you disable all Link up and down traps on the front panel interfaces, you

may still see link up traps reflecting the fact that cascade ports are initializing.

(Q00628942)

• A BPS 2000 hangs when it receives an EAP access reject from an ACS radius

server. The problem appears very quickly if you retrieve a show command

from the CLI. For example: show int or show EAPoL. (Q00666030)

• The EAPoL configuration parameter "Maximum Requests" has no effect.

The unit will only send out three EAP-Request/Identity frames before sending

a Failure frame and restarting the authentication process. (Q00637063)

• When you download the DSA Authorization key for the first time, the transfer

may time out. Simply re-initiate the key download sequence. (Q00626440)

• After rebooting the system, the Last key transfer result is not displayed

correctly. The display shows "Other: Error 0.", but the DSA-Key works

properly. (Q00597567)

• It may take up to 10 minutes for the DSA key to be generated, and you will

not receive a message when the generation is completed. You cannot

authenticate an SSH session to a switch using the DSA key authentication

until the key has been fully generated. (Q00627029)

• For port mirroring, all packets are sent to the monitor port after SSH has been

enabled and the stack has been rebooted. (Q00605912)

• If the DSA public key download fails, the following message will be

displayed if the action was initiated through the console port: "Cannot

modify settings, Undo Failed 1." No message is displayed if the

action was initiated through telnet, but the following message will appear in

the last transfer results of the "show ssh download" command:

"Other: Error 5." (Q00578979)

• You cannot enable SSH while the DSA public key is being generated. If you

attempt to enable SSH during the key generation period, you may see the

following error: "cannot modify settings." (Q00626985)

• If you have a DMLT configured, and one of the units that has a configured

link fails, the NNCLI displays the link as belonging to port yy. For example:

2/yy. (Q00624397)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 85 86

Žádné komentáře

Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 Oznámení Strana 21