Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 Oznámení stáhnout pdf (Strana 38)

215148-D

You configure this feature by enabling remote logging, specifying the IP address

of the remote syslog server, and specifying the severity level of the messages you

want sent to the remote server.

Configuring with NNCLI

You use the CLI to configure remote logging. This section discusses the following

topics:

• “show logging,” next

• “remote logging enable command” on page 39

• “no logging remote enable command” on page 40

• “logging remote address command” on page 40

• “no logging remote address command” on page 41

• “logging remote level command” on page 41

• “no logging remote level command” on page 42

• “default logging remote level command” on page 42

show logging

The show logging command displays the configuration and the current

contents of the system event log. The syntax for the

show logging command is:

show logging [config] [critical] [informational] [serious]

[sort-reverse]

The show logging command is in the privExec command mode.

Table 9 describes the parameters and variables for the show logging command.

Table 9 show logging command parameters and variables

Parameters and

variables

Description

config Displays the configuration of event logging.

critical Displays critical log messages.

informational Displays informational log messages.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 85 86

Žádné komentáře

Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 Oznámení Strana 38