Avaya Configuring Ethernet, FDDI, and Token Ring Services Uživatelský manuál stáhnout pdf (Strana 144)

Configuring Ethernet, FDDI, and Token Ring Services

B-26

308623-14.00 Rev 00

show token-ring errors

The

show token-ring errors

command displays receive, transmit, system, line, and ring

errors for all circuits or for a specific circuit or slot.

This command allows for the following command filters (flags) and filter arguments:

The output includes the following information:

-circuit

<circuit_name>

Displays information about the specified circuit only.

-slot

<slot>

Displays information about the specified slot only.

<circuit_name>

Displays information about the specified circuit only.

Receive Errors

Slot/Conn Slot location of the token ring module within the chassis and the

connector number.

Circuit Name of the circuit associated with this line.

Line Errors Number of frames that this station copied with bad format or Frame

Check Sequence (FCS) errors.

Burst Errors Number of frames with no bit transition for 5-1/2-bit times.

Transmit Errors

Slot/Conn Slot location of the token ring module within the chassis and the

connector number.

Lost Frame Errors Number of outbound frames whose transmission failed because

they were corrupted on their trip around the token ring. The interface

detects this condition while stripping a frame off the ring. In small

quantities, this error indicates small disturbances on the token ring.

System Errors

Slot/Conn Slot location of the token ring module within the chassis and the

connector number.

Adapter Checks Number of internal adapter errors that caused adapter failures.

DMA Bus Errors Number of bus errors during DMA that did not exceed the threshold.

DMA Parity Errors Number of parity errors during DMA that did not exceed the

threshold.

(continued)

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 155 156

Žádné komentáře

Avaya Configuring Ethernet, FDDI, and Token Ring Services Uživatelský manuál Strana 144