Avaya Configuring Interface and Router Redundancy Uživatelský manuál Strana 27

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 92
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 26
Interface Redundancy Overview
114079 Rev. B 1-5
You find the complete MAC address for the active interface in the interface
management information base (MIB) -- Ethernet or FDDI -- of the router on
which interface redundancy is configured. For example, if you are configuring
Ethernet, you can find the active MAC address in the Ethernet MIB by entering
the following command from the Technician Interface:
get wfCSMACDEntry.wfCSMACDMadr.*
Among the entries displayed in the MIB is the MAC address
0x 2
y yy
A2
xx xxxx
, which is used for interface redundancy. If you configure
more than one interface redundancy group on the same router, you will see more
than one entry with the same MAC address. This is not a problem because the two
redundancy groups are in different subnets.
Zobrazit stránku 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 91 92

Komentáře k této Příručce

Žádné komentáře